Confidently Practice Online with Free 156-836 Exam Cram

Practice your Check Point Certified Maestro Expert - R81 (CCME) certification test with free 156-836 exam cram and take control of your certification preparation. At FreeExamCram, you can practice online for free using real 156-836 exam dumps, verified questions, and expert-designed free online practice tests. Moreover our CheckPoint 156-836 exam cram backed by our confidence-boosting refund guarantee.

Question 1

What command should be used for collecting diagnostic information about the orchestrator?

Options :

A : cpinfo

B : asg perf -v

C : cpview

D : orch_info

Answer: A

Question 2

While looking at your system's correction statistics, you notice you have a correction rate approaching 100 percent. Is this a problem?

Options :

A : A correction rate above 90 percent indicates a need to disable Layer 4 Distribution.

B :

A correction rate approaching 100 percent of all connections is unusual. This is a cause for concern because the SGMs may fail to process traffic.

C : If correction rates are higher than 80 percent, latency is expected.

D :

In some scenarios, a correction rate approaching 100 percent of all connections is not unusual. This is not usually a cause for concern as the correction mechanism is fast and efficient.

Answer: B

Question 3

Which distribution mode assigns packets to an SGM based solely on the packet destination IP?

Options :

A : User mode

B : Manual mode

C : Network mode

D : Auto-topology mode

Answer: C

Question 4

What is the purpose of interface bonding?

Options :

A : A bond interface can be configured for high availability redundancy.

B : A bond interface is used for passing synchronization traffic between the SGMs.

C :

For load sharing which increases connection throughput above that which is possible using one physical interface.

D :

A bond interface can be configured for high availability redundancy or for load sharing which increases connection throughput above that which is possible using one physical interface.

Answer: D

Question 5

What is the purpose of Management ports located on the Rear Panel of the Orchestrator MHO-140?

Options :

A : 1Gbps connectivity for Security Groups

B : Reserved for internal purposes. Not in use.

C : Out-of-band interfaces for access to Orchestrator itself

D : Additional ports used as uplinks

Answer: C