Question 1

Refer to the exhibit.

A network engineer configures OSPF protocol between two Cisco Nexus 7000 Series Switches. The OSPF neighbors fail to synchronize OSPF databases. Which action resolves the issue?

Options :

A : Match the OSPF area between the two devices.

B : Configure the IP addresses of the interface in the same subnet.

C : Change the OSPF area type to 2 on n7k-1.

D : Set the same MTU values on both sides of the link.

Answer: D

Question 2

300-615-page127-image19

Options :

A :

Bind native VLAN 10 with Ethernet1/10 and allow VSAN 101 in trunk configuration.

B : Assign native VLAN 10 with vfc111 and allow VLAN 1101 in trunk configuration.

C :

Bind native VLAN 10 with Ethernet10/1/1 and allow VLAN 10 in trunk configuration.

D : Assign native VLAN 10 with fc2/1 - 2 and allow VLAN 10 in trunk configuration.

Answer: C

Question 3

An engineer troubleshoots a Cisco UCS B-Series environment and discovers that the status of the CNA is degraded in the CLI and the Cisco UCS Manager GUI. What should be done to resolve the issue?

Options :

A : Seat the blade server correctly in the chassis.

B : Install the adapter firmware version that is compatible with Cisco UCS Manager.

C : Install the server air baffles correctly.

D : Use the supported adapter on that server model.

Answer: D

Question 4

300-615-page127-image24

Refer to the exhibit. A network engineer configures an EEM script to get a syslog notification after a

configuration change. This message appears when the engineer makes a new configuration to this switch.

Which configuration enables the script to function properly?

Options :

A :

event cli match ‘configure terminal’

B : event policy-default count 1 time 100

C :

event syslog occurs 10

D : action 2.0 event-default

Answer: D

Question 5

A network engineer is implementing the Cisco ACI Fabric and notices that the Leaf-1 switch is registered, has

an assigned name, but is displayed as inactive in the APIC. After further investigation, it became clear that the

leaf switch was recently moved from another Cisco ACI environment. Which action resolves the problem?

Options :

A : Clean reload the Leaf-1 switch

B :

Define the new TEP address for Leaf-1

C :

Change the clock offset from low to high between apic 1 and Leaf-1

D : Modify the ISIS interface peering IP address between apic 1 and Leaf-1

Answer: B

Confidently Practice Online with Free 300-615 Exam Cram

Buying Options: