Question 1

Which command is typed at the CLI on the primary Cisco FTD unit to temporarily stop running highavailability?

Options :

A : configure high-availability resume

B : configure high-availability disable

C : system support network-options

D : configure high-availability suspend

Answer: B

Question 2

When creating a report template, how can the results be limited to show only the activity of a specific subnet?

Options :

A : Create a custom search in Firepower Management Center and select it in each section of the report.

B : Add an Input Parameter in the Advanced Settings of the report, and set the type to Network/IP.

C : Add a Table View section to the report with the Search field defined as the network in CIDR format.

D : Select IP Address as the X-Axis in each section of the report.

Answer: B

Question 3

A network administrator is implementing an active/passive high availability Cisco FTD pair.

When adding the high availability pair, the administrator cannot select the secondary peer.

What is the cause?

Options :

A : The second Cisco FTD is not the same model as the primary Cisco FTD.

B : An high availability license must be added to the Cisco FMC before adding the high availability pair.

C : The failover link must be defined on each Cisco FTD before adding the high availability pair.

D : Both Cisco FTD devices are not at the same software Version

Answer: A

Question 4

What is a characteristic of bridge groups on a Cisco FTD?

Options :

A : In routed firewall mode, routing between bridge groups must pass through a routed interface.

B : In routed firewall mode, routing between bridge groups is supported.

C : In transparent firewall mode, routing between bridge groups is supported

D : Routing between bridge groups is achieved only with a router-on-a-stick configuration on a connected router

Answer: B

Question 5

An engineer is configuring Cisco FMC and wants to allow multiple physical interfaces to be part of the same VLAN. The managed devices must be able to perform Layer 2 switching between interfaces, including subinterfaces. What must be configured to meet these requirements?

Options :

A : interface-based VLAN switching

B : inter-chassis clustering VLAN

C : integrated routing and bridging

D : Cisco ISE Security Group Tag

Answer: C

Confidently Practice Online with Free 300-710 Exam Cram

Buying Options: