Question 1

What action is taken automatically by 802.11 APs and client STAs as the signal strength of the link weakens in order to improve the quality of the RF communications overall?

Options :

A : Output power is increased

B : RSSI is increased

C : Data rates are reduced

D : Antenna gain is increased

Answer: C

Question 2

Given: Adjacent Channel Interference (ACI) can cause frame corruption and poor performance in WLANs. You are using a protocol analyzer in the attempt to detect ACI. What should you look for in such a scenario?

Options :

A : Look at Retry counts

B : Capture on the channel you think may be impacted by ACI and see if any frames are captured from adjacent channels

C : Look for frames with a low signal strength value in the radio tap header

D : Look at CRC errors

Answer: B

Question 3

What is encrypted within the third message of the 4-Way Handshake?

Options :

A : PMK

B : PTK

C : GMK

D : GTK

Answer: D

Question 4

A manufacturing facility has installed a new automation system which incorporates an 802.11 wireless network. The automation system is controlled from tablet computers connected via the WLAN. However, the automation system has not gone live due to problem with the tablets connecting to the WLAN. The WLAN vendor has been onsite to perform a survey and confirmed good primary and secondary coverage across the facility. As a CWAP you are called in to perform Spectrum Analysis to identify any interference sources. From the spectrum analysis, you did not identify any interference sources but were able to correctly identify the issue. Which of the following issues did you identify from the spectrum analysis?

Options :

A : The tablets are connecting to the wrong SSID

B : The tablets are entering power save mode and failing to wake up to receive the access points transmissions

C : A high noise floor has resulted in a SNR of less than 20dB

D : There is a power mismatch between the APs and the clients

Answer: D

Question 5

After examining a Beacon frame decode you see the SSID Element has a length of 0. What do you conclude about this frame?

Options :

A : The frame is corrupted

B : SSID elements always have a length of 0

C : This is a common attack on WISP backend SQL databases

D : The beacon is from a BSS configured to hide the SSID

Answer: D

Confidently Practice Online with Free CWAP-405 Exam Cram

Buying Options: