Question 1

Refer to the exhibit.

As an administrator you have created an IPS profile, but it is not performing as expected. While testing you got the output as shown in the exhibit. What could be the possible reason of the diagnose output shown in the exhibit?

Options :

A : There is a no firewall policy configured with an IPS security profile.

B : FortiGate entered into IPS fail open state.

C : Administrator entered the command diagnose test application ipsmonitor 5.

D : Administrator entered the command diagnose test application ipsmonitor 99.

Answer: A

Question 2

Refer to the exhibit.

The NOC team connects to the FortiGate GUI with the NOC_Access admin profile. They request that their GUI sessions do not disconnect too early during inactivity. What must the administrator configure to answer this specific request from the NOC team?

Options :

A : Move NOC_Access to the top of the list to ensure all profile settings take effect.

B : Increase the offline value of the Override Idle Timeout parameter in the NOC_Access admin profile.

C : Ensure that all NOC_Access users are assigned the super_admin role to guarantee access

D : Increase the admintimeout value under config system accprofile NOC_Access.

Answer: D

Question 3

You have configured the below commands on a FortiGate.

What would be the impact of this configuration on FortiGate?

Options :

A : FortiGate will enable strict RPF on ail its interfaces and port1 will be enable for asymmetric routing.

B : FortiGate will enable strict RPF on all its interfaces and port1 will be exempted from RPF checks.

C : Port1 will be enabled with flexible RPF, and all other interfaces will be enabled for strict RPF

D : The global configuration will take precedence and FortiGate will enable strict RPF on all interfaces.

Answer: B

Question 4

Which three statements about SD-WAN performance SLAs are true? (Choose three.)

Options :

A : They rely on session loss and jitter.

B : They can be measured actively or passively

C : They are applied in a SD-WAN rule lowest cost strategy

D : They monitor the state of the FortiGate device.

E : All the SLAtargets can be configured.

Answer: A,B,E

Question 5

Refer to the exhibit, which shows an SD-WAN zone configuration on the FortiGate GUI.

Based on the exhibit, which statement is true?

Options :

A : The Underlay zone is the zone by default.

B : The Underlay zone contains no member.

C : port2 and port3 are not assigned to a zone.

D : The virtual-wan-link and overlay zones can be deleted.

Answer: A

Confidently Practice Online with Free FCP_FGT_AD-7.6 Exam Cram

Buying Options: