Question 1

Which three steps are executed to get antivirus and IPS updates using the pull method? (Choose three.)

Options :

A : FortiGate starts sending rating queries to one of the servers in the list.

B : FortiGate periodically queries for pending updates.

C : FortiGate gets a list of server IP addresses that can be contacted.

D : FortiGate contacts a DNS server to resolve the FortiGuard domain name.

Answer: A,B,D

Question 2

Examine these partial outputs from two routing debug commands:

Why is the default route that uses port2 not in the output of the second command?

Options :

A : It has a higher distance than the default route using port1.

B : There can be only one default route present in an active routing table.

C : It is disabled in the FortiGate configuration.

D : It has a higher priority than the default route using port1.

Answer: A

Question 3

View the exhibit, which contains a hub-and-spoke VPN topology with two hubs.

An administrator wants to configure ADVPN.

Which ADVPN setting must be enabled in the tunnel between the Hub1 and Hub2 FortiGate devices?

Options :

A : set auto-discovery-receiver enabled

B : set auto-discovery-forwarder enabled

C : set auto-discovery-sender enabled

D : set auto-discovery-ipsec enabled

Answer: A

Question 4

Refer to the exhibit.

An administrator is deploying a hub and spokes network and using OSPF as dynamic protocol. Which configuration is mandatory for neighbor adjacency?

Options :

A : Set bfd enable in the router configuration

B : Set network-type point-to-multipoint in the hub interface

C : Set rfc1583-compatible enable in the router configuration

D : Set virtual-link enable in the hub interface

Answer: B

Question 5

Refer to the exhibit, which shows the output of a debug command.

What can be concluded from the debug command output?

Options :

A : The OSPF router with the ID 0.0.0.69 has its OSPF priority set to 0.

B : The local FortiGate has a different MTU value from the OSPF router with ID 0.0.0.2, based on the state information.

C : There are more than two OSPF routers on the wan2 network.

D : The interface ToRemote is a broadcast OSPF network.

Answer: C

Confidently Practice Online with Free FCSS_EFW_AD-7.4 Exam Cram