Question 1

On the OSPF network shown in the figure, all IP addresses can communicate with each other. Then the following configurations are added on R1:Which IP address of S1 can successfully ping 10.2.23.3?

Options :

A : 10.1.1.1

B : 10.2.1.1

C : 10.3.1.1

D : 10.0.1.1

Answer: B

Question 2

OSPF has five types of packets. Which type is used to notify an OSPF neighbor of its required LSAs?

Options :

A : DD

B : LSR

C : LSU

D : Hello

Answer: B

Question 3

With the continuous development of AI, data center application scenarios are gradually divided into generalpurpose computing and intelligent computing scenarios. Data centers need to ensure service continuity of general-purpose computing clusters while unleashing the full potential of intelligent computing clusters, so as to guarantee stable and efficient operation in the AI era. Which of the following statements are true about the service requirements of data center networks in the two scenarios? (Select all that apply)

Options :

A : The general-purpose computing network demands a well-defined hierarchy, adopting a coreaggregation-access three-layer architecture.

B : The general-purpose computing network requires high network stability and efficiency. Technologies such as M-LAG can be used to implement fast failover, and VXLAN can be deployed to build a large Layer 2 network for VM migration.

C : The intelligent computing network requires zero packet loss, which necessitates the deployment of various lossless network technologies such as PFC and ECN.

D : The intelligent computing network requires ultra-low latency, including the latency of data transmission within a compute node. The latency can be further reduced by using the RoCE protocol.

Answer: B,C

Question 4

In the figure, both PC1 and PC2 belong to VLAN 10. Interface GE1/0/1 on SW1 is a trunk interface with the default PVID, and interface GE1/0/2 on SW1 is an access interface in VLAN 10. Which of the following statements are true about the forwarding of data frames between PC1 and PC2? (Select all that apply)

Options :

A : After receiving the data frame sent from PC1 to PC2, SW1 adds the VLAN 10 tag to the data frame and then accepts the data frame.

B : SW1 accepts the data frame sent from PC1 to PC2, but discards the data frame returned from PC2 to PC1.

C : The data frame processed inside SW1 does not carry any VLAN tag.

D : SW1 removes the VLAN 10 tag from the data frame before forwarding it from GE1/0/2 to PC2.

Answer: A,D

Question 5

Which of the following configurations can enable connectivity between interfaces on R1 and R3? (Select all that apply)

Options :

A : [R1] ip route-static 20.1.1.0 24 10.0.0.2

B : [R1] ip route-static 20.1.1.0 24 20.1.1.2

C : [R3] ip route-static 10.0.0.0 24 20.1.1.2

D : [R3] ip route-static 10.0.0.0 24 20.1.1.1

Answer: A,D

Confidently Practice Online with Free H12-811_V2.0 Exam Cram

Buying Options: