Confidently Practice Online with Free H35-210_V2.5 Exam Cram

Practice your HCIA-Access V2.5 certification test with free H35-210_V2.5 exam cram and take control of your certification preparation. At FreeExamCram, you can practice online for free using real H35-210_V2.5 exam dumps, verified questions, and expert-designed free online practice tests. Moreover our Huawei H35-210_V2.5 exam cram backed by our confidence-boosting refund guarantee.

Question 1

The routing table of a router contains the following two entries: Destination/Mask Protocol Pre Cost Nexthop Interface 9.0.0.0/8 OSPF 10 50 1.1.1.1 Serial0 9.1.0.0/16 RIP 100 5 2.2.2.2 Ethernet0 If the router needs to forward packets with the destination address of 9.1.4.5, which of the following statements is correct?

Options :

A : The router selects the first route, because the priority of OSPF is higher.

B :

The router selects the second route, because this route matches the destination address 9.1.4.5 more accurately.

C : The router selects the second route, because the metric of RIP is smaller.

D :

The router selects the second route, because the outbound interface is Ethernet0, which is faster than Serial0.

Answer: B

Question 2

The OLT supports the ( ) VLAN attributes. (Select All that Apply)

Options :

A : MUX

B : Stacking

C : Common

D : QinQ

Answer: B,C,D

Question 3

After the server receives the DHCP REQUEST packet, if the server cannot allocate an IP address due to certain reasons, the server sends the ( ) packet as a response.

Options :

A : DHCP REFRESH

B : DHCP DISCOVER

C : DHCP REQUEST

D : DHCPNAK

Answer: D

Question 4

In a GPON network, which of the following may cause the ONT to fail to be discovered? (Select All that Apply)

Options :

A : The optical power received by the ONT is less than the sensitivity threshold.

B : The ONT auto-find function of the GPON port is disabled.

C : The upstream port of the OLT is down.

D : The optical power received by the ONT is greater than the overload optical power.

Answer: A,B,D

Question 5

Which of the following commands can be used to query the receive optical power of an ONU?

Options :

A : display ont optical-info

B : display pon optical-info

C : display board

D : display port state

Answer: A