Question 1

Exhibit

You are asked to configure OSPF between routers R1 and R2 using IPv6 addresses.

Which two tasks will accomplish your objective? (Choose two.)

Options :

A : Issue the sec protocols ospf area 0.0.0.0 interface ge-0/0/1.0 command.

B : Under the [edit routing-options] hierarchy, configure a 32-bit router ID.

C : issue the set protocols ospf3 area 0.0.0.0 interface ge-0/0/1.0 command.

D : Under the [edit routing-options] hierarchy, configure a 128-bit router ID.

Answer: A,D

Question 2

Exhibit.

Referring to the exhibit, you have configured an aggregate route that represents the 172.21.0.0/24,

172.21.1.0/24, and 172.21.2.0/24 networks. However, when you view the routing table, your new route

hidden.

Which action would you perform to determine the problem?

Options :

A :

Verify that you have active contributing routes on the device.

B :

Verify that you have configured a policy on the device to accept aggregate routes.

C :

Verify that you have defined a metric value for the aggregate route.

D :

Verify that you have set the preference to a lower default value.

Answer: D

Question 3

Click the Exhibit button.

Referring to the exhibit, which two statements are correct? (Choose two.)

Options :

A : Traffic ingressing ge-1/0/0 that is tagged with VLAN 200 will be dropped.

B : Traffic ingressing ge-1/0/0 that is tagged with VLAN 100 will be dropped.

C : Traffic ingressing ge-1/0/0 that is tagged with VLAN 100 will egress ge-1/0/4 with an outer VLAN tag of 200.

D : Traffic ingressing ge-1/0/0 that is tagged with VLAN 200 will egress ge-1/0/4 with an outer VLAN tag of 200

Answer: A,C

Question 4

You are bringing a new network online with three MX Series devices enabled for STP. No root bridge priority

has been configured. Which statement is true in this scenario?

Options :

A : The device with the lowest MAC address will be elected as the root bridge.

B : The device with the highest MAC address will be elected as the root bridge.

C : The device with the lowest numerical lo0 IP address will be elected as the root bridge.

D : The device with the highest numerical lo0 IP address will be elected as The bridge.

Answer: A

Question 5

Which statement is true about the BGP active state?

Options :

A : The BGP active state is the initial state where all BGP traffic is refused.

B : The BGP active state is when BGP attempts to acquire a peer by initiating a TCP connection

C : The BGP active state is when BGP waits for the TCP connection to be established.

D : The BGP active state is when BGP exchanges update, notification, and keepalive messages with its peer.

Answer: B

Confidently Practice Online with Free JN0-363 Exam Cram

Buying Options: