Question 1

What will be observed in the NC2 cluster when terminating a node from the Azure portal?

Options :

A : NC2 will shutdown the node.

B : NC2 will continue re-provisioning the node.

C : NC2 will terminate the node from the cluster.

D : NC2 will mark the node as degraded.

Answer: D

Question 2

What is an available log module when configuring a syslog server in the Prism Central Admin Center?

Options :

A : Prism

B : Zookeeper

C : API Audit

D : Acropolis

Answer: D

Question 3

Exhibit.

AN NC2 on Azure Cluster was deployed with two Flow gateways in HA (FGW1 and FGW2). After a week of use. Four bare-metal nodes, were added to the NC2 cluster and additional workloads were added. It was determined that additional bandwidth for north/South traffic would be needed. Two additional Flow gateways were added (FGW3 and FGW4) from the NC2 portal configuration menu. The existing workloads prior to expansion on the NC2 cluster will be able to use which Flow Gateways using the No-Nat (routed) traffic path?

Options :

A : Only the Flow Gateway that each workload was originally using.

B : All Flow Gateways can be used.

C : All Flow Gateways can be used after the existing workloads reboot.

D : FGW1&FGW2 only, new workloads can use FGW3 & FGW4.

Answer: B

Question 4

An administrator needs to extend an on-premises subnet to an NC2 cluster on Azure. Which set of options should the administrator configure to complete this task?

Options :

A :

Subnet Type: VPC subnets Traffic Type: IPv4 unicast traffic and ARP On-premises Hypervisor: ESXi, AHV, Hyper-V

B :

Subnet Type: On-premises VLAN subnets and VPC subnets Traffic Type: IPv4 unicast traffic IPv6 unicast traffic and ARP On-premises Hypervisor: ESXi and AHV

C :

Subnet Type: On-premises VLAN subnets and VPC subnets Traffic Type: IPv4 unicast traffic and ARP On-premises Hypervisor: AHV

D :

Subnet Type: On-premises VLAN subnets and VPC subnets Traffic Type: IPv6 umcasi traffic and ARP On-premises Hypervisor: Hyper-V

Answer: B

Question 5

An on-premises network has been extended to azure with a VPN/ExpressRoute. The routing and peering of VNets is setup and has been confirmed to be correct. Which statement best describes the state of the traffic flow between the on-prem CVMs and the NC2 CVMs in Azure?

Options :

A :

The Network Security Group of the Flow Gateway VM on the Internal NICs will need to be edited to enable the traffic flow.

B : A ticket will need to be put in with Microsoft support to open the subnet ranges from on-premises.

C : Traffic will flow directly to the NC2 CVMs. Nothing will block the path by default.

D :

The Network Security Group of the Flow Gateway VM on the Externa! NICs will need to be edited to enable the traffic flow.

Answer: A

Confidently Practice Online with Free NCP-CI-Azure Exam Cram

Buying Options: