Question 1

Anadministrator recently added VLAN 205 CRM in Prism Element. The workloads attached to the associated NICs are unable to establish network connectivity. Which Layer 2 protocol allows the administrator to troubleshoot this issue from Prism Element?

Options :

A : HDLC

B : SUP

C : LACP

D : LLDP

Answer: D

Question 2

An administrator is supporting a business critical environment and deploys metro availability to achieve a zero

data loss configuration. The two clusters are connected by a 1GbE connection. A new workload is going to be

deployed to this cluster. This workload requires a sustained 150MB/S of write throughput and 20MB/s of read

throughput.

Which change must be made to deploy the workload successfully on this cluster?

Options :

A : The bandwidth must be increased tosupport this workload.

B : The workload must be configured to read at greater than 12.5MB/S.

C : The replication frequency must be less than 60 minutes.

D : Zero data loss nearsync must be used to support this workload.

Answer: A

Question 3

An administrator needs to make sure an RF2 cluster can survive a complete rack failure without negatively

effecting workload performance. The current cluster configuration consists of thefollowing:

• 30 nodes: distributed 10 nodes per rack across three 42U rack

• Each nodes is configured with 40TB usable storage all flash (Cluster Total 1.2 PB Usable)

• Current cluster utilization is 900TB storage

Which configuration changes should be made to make sure that the cluster meets the requirements?

Options :

A : Expanse the cluster by adding 3 additional nodes per rack, 9 nodes total.

B : Expanse the cluster by adding 2 additional nodes per rack, 6 nodes total.

C : Expanse thecluster by adding 9 nodes to a new 42U rack

D : Expanse the cluster by adding 8 nodes to a new 42U rack

Answer: A

Question 4

A consultant is unable to ping the CVM from the hypervisor using the external interface. The customer's network is configured with the 10.3.12.0/24 subnet without VLAN tagging. The CVM and hypervisor are using the same address space. What is causing this issue?

Options :

A : The 1GbE and 10GbE NICs have not been separated.

B : The default gateway is incorrect.

C : The switch is trunked without a native VLAN.

D : The CVM/hypervisor only communicates over 192.168.5.0/24.

Answer: B

Question 5

A VM does not have enough resources for the demand,which leads to performance bottlenecks. The VM is exhibiting one or more of following baseline values, based on the past 30 days: • CPU usage > 90% (moderate), 95% (high) • CPU ready time > 5%, 10% • Memory usage > 90%, 95% • Memory swap rate > 0Kbps (no moderate value) Which type of VM is being described?

Options :

A : Constrained VM

B : Bully VM

C : Inactive VM

D : Over-provisioned VM

Answer: A

Confidently Practice Online with Free NCS-Core Exam Cram

Buying Options: